WARNING!
• To reduce the risk of accidental starting, always make sure
the switch is in the OFF ( O ) position before plugging tool
into the power source.
WARNING!
• ALWAYS remove the switch key when the tool is not in
use and keep it in a safe place. In the event of a power
failure, turn the switch OFF ( O ) and remove the key. This
action will prevent the tool from accidentally starting when
power returns.
WARNING!
• ALWAYS make sure your workpiece is not in contact with
the blade before operating the switch to start the tool.
Failure to heed this warning may cause the workpiece to
be kicked back toward the operator and result in serious
personal injury.
Fig. 36
1
CAUTION!
Make sure you read the general safety guidelines for the table
saw before operating it. Your safety depends on it. Verify the
following every time the saw is used:
• The blade is tight.
• The bevel angle locking knob is tight.
• If ripping, the fence locking handle is tight, the fence is parallel
and the mitre gauge locking handle is tight.
• If crosscutting, the mitre gauge knob is tight.
• The blade guard and riving knife are in place and are working
properly.
• Safety glasses are being worn.
Failure to adhere to these safety rules can greatly increase the
chances of injury.
WARNING!
Do not use blades rated less than the speed of this tool. Failure
to heed this warning could result in personal injury.
WARNING!
Overheating may be caused by misaligned parts or by a dull
blade. Inspect the saw for proper setup before using it again.
3938
TO LOCK YOUR SAW:
• Press the switch down.
• Remove the switch key from the switch and store
in a safe, secure location.
OVERLOAD PROTECTION (Fig. 36)
The saw is equipped with an overload switch (1) to
prevent the saw from overload damage. The saw
will stop if the machine was overloaded with cutting
or low voltage. Turn the switch to the Off position
and allow the motor to cool down for at least five
minutes. Press the overload switch button to
reactivate the overload switch. After the motor has
cooled down, turn the switch to the On position. The
saw should now start.
MAKING CUTS
Before using the table saw, polish the table with an automotive wax in order to keep it
clean and make it easier to slide the workpiece.
There are two basic types of table saw cuts: ripping and crosscutting. In general, ripping
means cutting with the grain, along the length of the workpiece. Crosscutting means
either cutting across the width or across the grain of the workpiece. However, with
man-made materials, this distinction can be difficult to make.
Therefore, cutting a piece of wood to a different width is ripping and cutting across the
short dimension is crosscutting. Neither ripping nor crosscutting operations can be
performed safety freehand: ripping requires the use of the rip fence, and crosscutting
requires the use of the mitre gauge.
model no. 055-6766-2 | contact us 1-888-670-6682
OPERATION
model no. 055-6766-2 | contact us 1-888-670-6682
OPERATION
To Next Page
Loading...
