10
model no. 055-6767-0 | contact us 1-888-670-6682
• People with electronic devices, such as pacemakers, should consult their physician(s)
before using this product. Operation of electrical equipment in close proximity to a
heart pacemaker could cause interference or failure of the pacemaker.
• WEAR HEARING PROTECTION to reduce the risk of induced hearing loss.
SPECIFIC SAFETY INSTRUCTIONS FOR THIS SLIDING MITRE SAW
• DO NOT operate the mitre saw until it is completely assembled and installed
according to these instructions.
• IF YOU ARE NOT thoroughly familiar with the operation of mitre saws, seek guidance
from your supervisor, instructor or other qualified person.
• ALWAYS hold the work firmly against the fence and table. DO NOT perform any
operation free hand (use clamp wherever possible).
• KEEP HANDS out of the path of the saw blade. If the workpiece you are cutting
would cause your hands to be within 7 1/2" (19 cm) of the saw blade, the workpiece
should be clamped in place before making the cut.
• BE SURE the blade is sharp, runs freely and is free of vibration.
• ALLOW the motor to come up to full speed before starting a cut.
• KEEP THE MOTOR AIR SLOTS CLEAN and free of chips or dust.
• ALWAYS MAKE SURE all handles are tight before cutting, even if the table is
positioned in one of the positive stops.
• BE SURE both the blade and the collar are clean and the arbour bolt is tightened
securely.
• USE only blade collars specified for your saw.
• NEVER use blades larger in diameter than 10 inches.
• NEVER apply lubricants to the blade when it is running.
SAFETY GUIDELINES
WARNING!
• Dust generated from certain materials can be hazardous to your health.
Always operate saw in well-ventilated area and provide for proper
dust removal.
To Next Page
Loading...
Need help?
General
