26
model no. 055-6767-0 | contact us 1-888-670-6682
REMOVING OR INSTALLING THE SLIDING
FENCE (Fig. 11)
Removing
• Unlock the fence cam locking lever (1)
by pushing it out towards the rear of
the machine.
• Align the slot (2) with the bolt (3) in the
rear of the fence, and then lift up the sliding
fence to remove it from the saw.
Installing
• Align the slot (2) with the bolt (3) in the
rear of the fence to place the sliding fence
onto the mitre saw fence.
• Slide the nut (4) to align the nut (4) with
the slot (5).
• To lock the sliding fence, push the cam
locking lever (1) in towards the front of
the machine.
ASSEMBLY
Fig. 11
WARNING!
• DRY RUN - It is important to know where the blade will intersect with the
workpiece during cutting operations. Always perform a simulated cutting
sequence with the power tool switched OFF to gain an understanding
of the projected path of the saw blade. At some extreme angles, the left
side or the right side sliding fence might have to be removed to ensure
proper clearance prior to making the cut.
CAUTION!
• The left sliding fence must be removed when making any left bevel angle
cuts greater than 33.9° in combination with any right or left mitre angle.
This left sliding fence must also be removed whenever a 45° bevel angle
is desired with a mitre angle greater than 31.6°.
• The right sliding fence must be removed when making any right bevel
angle cuts.
1
4
2
3
5
To Next Page
Loading...
Need help?
General
