MaxJax™ Portable Mid-Rise Lift 10 P/N 5900268 — Rev. A4 — July 2022
Hydraulic System Warnings
⚠ WARNING Failure to observe these precautions can result in serious personal injury, including,
in rare cases, death.
⚠ WARNING Do not run your Power Unit without Hydraulic Fluid; it will be damaged.
⚠ WARNING All Hydraulic Hose fittings must be inspected before any attempt is made to raise a
Vehicle.
⚠ WARNING Do not attempt to connect or disconnect Hydraulic Hoses while equipment is
loaded or while the Hydraulic System is under pressure.
⚠ WARNING Keep the Hydraulic System clean; keep the Quick-Connect Fittings free of debris.
⚠ WARNING Keep bare hands away from Hydraulic Fluid; always wear gloves when handling
Hydraulic Cylinders or Hydraulic Hoses.
⚠ WARNING Before applying power to the Hydraulic system, systematically verify all hydraulic
connections are tight, including fittings, hoses, and auxiliary port plugs. Inspect for
pinched or damaged Hydraulic Hoses and replace before operation.
⚠ WARNING When handling Hydraulic Fluid, observe the safety instructions from the
manufacturer.
⚠ WARNING This Hydraulic Power Unit cannot be run continuously. The motor is not rated for
continuous duty.
⚠ WARNING The MaxJax is a Hydraulicly Balanced Lift. The Hydraulic Hoses supplying the Lift
Cylinders must be the same length within 5%. If a hose is replaced verify the length
is within 5% of the original MaxJax Hydraulic Hose.
⚠ WARNING This Power Unit contains a Hydraulic Pump capable of developing extremely high
pressure. A Pressure Relief Valve is used to set the pressure at the desired level.
Tampering with, adjusting, modifying, or removing the Relief Valve is extremely
dangerous. Only trained Hydraulics technicians, using calibrated Hydraulic Pressure
Gauges to assure the proper pressure setting is achieved, should make
adjustments to the Relief Valve.
Additional Operating Information
Keep the following in mind when operating your MaxJax:
• Use it only on a hard, flat surface. MaxJax is portable; if you move it to a new location, make sure
the location has a hard, flat surface.
• Always verify that you have the proper overhead clearance.
•
Visually inspect the Lift before each use
. Do not use it if you find any damage or severe
wear to the Lift components.
• Both Posts
must
be anchored in place when the Lift is in operation.
To Next Page
Loading...
