MaxJax™ Portable Mid-Rise Lift 19 P/N 5900268 — Rev. A4 — July 2022
Maintenance
⚠
DANGER Before performing maintenance on your Lift, verify it is disconnected from power.
The Lift uses electrical energy; if your organization has Lockout/Tagout policies,
make sure to implement them before performing any maintenance. If you come into
contact with high voltage/current, you could be injured or killed.
A complete pre-operation inspection is required before using this equipment.
Read your manual and understand how this equipment works before using, maintaining or repairing.
Routine maintenance and adjustments are the responsibility of the owner/user and are not covered
under warranty.
Routine maintenance and adjustments should be carried out on a regular basis. Unless stated
otherwise, all maintenance may be performed by the owner/employer and does not require trained lift
service personnel. Replace worn, damaged or broken parts with original BendPak or BendPak
approved parts or with parts that meet or exceed the original specifications.
Routine maintenance and adjustments are the responsibility of the owner/user and are not
covered under warranty.
To maintain your Lift:
• Daily: Keep the Lift clean. Wipe up any oil spills, clean any dirt.
• Daily: Make a visual inspection of all moving parts and check for damage or excessive wear. If
you find any damaged or worn parts, take the Lift out of service until they are replaced.
• Daily: Make sure the Safety Locks are in good operating condition. If you find that the Safety
Locks are damaged or excessively worn, take the Lift out of service until they are replaced.
Do
not use your Lift if the Safety Locks are damaged or excessively worn
.
• Daily: If the CE Safety Release Kit is installed, verify the Safety Locks engage and disengage
freely. If you find that the Safety Release mechanism is damaged or excessively worn, take the Lift
out of service until is repaired or replaced.
• Daily: Verify the Cylinder Clamp is secured and in place at the top of the Lift Head.
• Weekly: Check all controls to make sure they are functioning normally.
• Weekly: Check all labels on the unit. Replace them if they are illegible or missing.
• Monthly: Lubricate the inside of the Posts where the Lift Head’s Slide Blocks move. We
recommend using white lithium grease or similar.
• Monthly: Make sure all pivot arm pins are properly secured.
• Monthly: Check the Power Unit’s Hydraulic Fluid levels. Refill if low.
⚠ WARNING If one of the long Hydraulic hoses requires replacement, replace it with a hose of
the same length ±5%. The MaxJax is a Hydraulically Equalized Lift. Unequal Hose
lengths may cause unequal lifting, resulting in an imbalance and subsequent loss of
load. Order a replacement hose, contact MaxJax support at
maxjax.com/support, via email support@maxjax.com, or call (844) 629-
5291.
⚠ WARNING Do not operate your Lift if you find maintenance issues; instead, take it out of
service, then contact your dealer, email support@maxjax.com, visit
maxjax.com/support, or call (844) 629-5291.
To Next Page
Loading...