5
abundant sunshine.
The solar panel open-circuit voltage should be 14-40v.The maximum
charging power of this product is 125W.
Connect the solar panel and the product using solar charging cable. Make
sure that the solar charging cable is correctly connected and forming a solid
contact with the input port of the product.
This product is built-in advanced system control circuit module. When the
battery is full charged, it will stop charging automatically.
B. Charge with AC Adapter
Please use the AC charger equipped with this product to charge. You can
know the charging status of this product through the LCD screen. This product
is built-in advanced system control circuit module. When the battery is full
charged, the product will stop charging automatically.
C. Charge with Car Charger
Please use the original car charger. Insert one end of the car charger to the
car cigarette lighter and insert the other end to the input port of the product. The
LCD battery will blink to indicate that the product is being charged normally.
Note: A car with 12V starting battery can't charge this PPS fully, but a car
with 24V battery can charge it fully. You'd better start the car when you charge
this PPS.
How to Jump-Start a Car
Precautions before jump-starting a car:
1.Make sure the engine displacement of the vehicle (or other motor vessels,
here take a car for example) is no more than 4L.
2. Make sure the PPS power is over 60% (four battery segments on).
3. Make sure the clamps on jump-start cable is not broken.
Steps:
1. Clamp the red clip to car battery positive pole and the black clip to the
battery negative pole.
2. Plug the other end of jump-start cable into your PPS.
3. Turn the key to start your car as normal.
4. After starting, remove the cable from this product rst, then remove red
and black clip.
To Next Page
Loading...
Need help?
General
