Maintenance
Care & Maintenance
14 maxon BIKEDRIVE | User Manual | rel6003
3) Check for damage: Check motor, battery, cables, and plug connectors
for external damage. Let your authorized BIKEDRIVE dealer replace
any damaged part immediately.
4) Charge battery:
a) Connect battery charger with battery.
b) Connect battery charger to power outlet (100…240 VAC, 50…60 Hz)
and switch on.
The start of the charging process is indicated by a green battery
charger LED in combination with all white battery LEDs.
During the charging process, an amber battery charger LED and,
according to the charging level, the white battery LEDs light up.
Full battery load is indicated by a green battery charger LED and
the switched off battery.
If no battery is connected to the battery charger, a red battery char-
ger LED will light up.
c) Disconnect battery from battery charger.
d) Disconnect battery charger from power plug.
5) Store battery in a cool dry place. For example, do not let the battery
in your car when it is exposed to direct sunlight since it can get
extremely hot in a very short time! Also, observe the permitted envi-
ronmental conditions (page 27)!
2.1.2 Storage of the Battery
Store the battery in a cool, dry place. For information on the maximum permit-
ted storage temperature see Table 4 on page 27.
Long-term
storage
If you are not using the battery for extended periods, store it at approximately
60% of its capacity. A permanently higher charge will accelerate the principle-
related natural aging of the battery.
WARNING
Risk of injury
Wrong charging current or penetrating humidity can damage the battery and
can lead to serious injury!
• Use only an original BIKEDRIVE battery charger to recharge the battery!
• During the charging process, protect the battery, battery charger, and plug
connectors from contact with humidity (water, dew, cleaning agents, etc.) and
observe the permitted environmental conditions (
section “3 Technical Data”
on page 25)!
• Do not carry out any cleaning or maintenance on the bike while charging is
ongoing!
• Do not leave charger and battery unattended during the charging process!
To Next Page
Loading...
Need help?
General