Maintenance
Care & Maintenance
maxon BIKEDRIVE | User Manual | rel6003 15
2.1.3 Periodic Inspection
In addition to the maintenance specified by the bike manufacturer, you or your
authorized BIKEDRIVE dealer must perform the following inspections.
Table 1 Maintenance Plan
2.1.4 Replacing the rear Brake Disc
2.1.4.1 Dismantling
When? What?
After heavy use
Brakes: Check wear on brake discs and brake pads,
replace if necessary
Every 200 km
or
at least annually
• Rear wheel: Check on specified spoke tension
• Quick-release axle: Check on specified torque
• Screw connections: Check for firm fit
• Plug connections: Check for firm fit
Every 1000 km
or
at least annually
Battery rail: Check for firm fit
Every 6 months
Battery: Fully recharge the battery and disconnect
from battery charger. Then discharge to
approximately 60%.
IMPORTANT!
During disassembly, exposed parts can easily be damaged. Exercise caution.
Remove
cover
1) Disconnect motor plug from
Power Cable.
2) Dismantle rear wheel.
3) Loosen and remove screws
(A).
4) Carefully pull off cover (B).
To Next Page
Loading...
Need help?
General