Maxon DMD series - Raising and Unloading Platform; Moving Load into Vehicle; Lowering Platform After Raising

15
2. Carefully move the load
into vehicle (FIG. 15-1).
RAISING & UNLOADING PLATFORM
A ramp in retention position can trip you when stepping over it.
To prevent possible injury, get on the platform before putting the
ramp in retention position.
CAUTION
!
1. Use inboard control switch
to raise (UP) platform from
ground level to bed height
(FIG. 15-1). Release toggle
switch when platform
reaches bed height.
INBOARD CONTROL
SWITCH (UP)
3. Use inboard control
switch to lower (DOWN)
the platform to ground
level (FIG. 15-2).
MOVING LOAD INTO VEHICLE
FIG. 15-1
4. If there are more loads
to put in vehicle, repeat
the previous LOADING
VEHICLE steps for
each load. When
loading is fi nished, use
STOWING PLATFORM
procedure in this
manual.
LOWERING PLATFORM
FIG. 15-2
INBOARD CONTROL
SWITCH (DOWN)