Maxon DMD series - Lowering and Unloading Platform; Lowering Platform to Ground; Moving Load Off Platform

18
1. Use outboard control switch
to lower (DOWN) platform
to the ground (FIG. 18-1).
Release toggle switch
when platform reaches
ground level.
Before lowering platform, make sure area surrounding platform is
clear of people and objects. If standing on platform, do not allow
your feet to extend beyond inboard edge of platform.
WARNING
!
2. Carefully move load off platform
(FIG. 18-2) and then move it to
a place where it will not become
a hazard for people and other
vehicles. If there is more to
unload from vehicle, repeat
the previous UNLOADING
VEHICLE steps for each load.
When unloading is fi nished,
use STOWING PLATFORM
procedure in this manual.
LOWERING & UNLOADING PLATFORM
MOVING LOAD OFF PLATFORM
FIG. 18-2
OUTBOARD
CONTROL
SWITCH
(DOWN)
LOWERING PLATFORM TO GROUND LEVEL
FIG. 18-1