Maxon GPSLR Series

To Next Page

To Previous Page

1. Unchain Liftgate by un-

hooking snap hook from

tilt arm (FIG. 16-1).

2. Hold the external up-down

toggle switch in the DOWN

position (FIG. 16-2) until

lowest point of platform

and arms are 6” above the

ground (FIG. 16-3).

DOWN SWITCH

FIG. 16-2

NOTE: If necessary, release the

toggle switch to stop the

platform from moving.

OPERATION

UP-DOWN

TOGGLE SWITCH

LOWEST POINT 6” ABOVE GROUND

FIG. 16-3

Damage will occur if Liftgate

is not in correct position when

operating the slide function.

Ensure platform & arms have

6” of ground clearance, at low-

est point, before Liftgate is run

out from under vehicle.

CAUTION

Ensure Liftgate is unchained before you deploy Liftgate for

operation. Possible injury and equipment damage could result.

CHAIN

SNAP HOOK

UNCHAINING LIFTGATE

FIG. 16-1

TILT ARM

6”

GROUND

Maxon GPSLR Series - Operation