LIFT CORPORATION Sht. 4 of 10 DSG# M-18-02 Rev. - Date: 10/11/18
© MAXON Lift Corp. 2018
CUTTING LH MOUNTING PLATE BRACKET (IF REQUIRED)
FIG. 4-1
LH MOUNTING
PLATE BRACKET
MAIN FRAME
MAIN FRAME
FIG. 4-1A
LH MOUNTING
PLATE BRACKET
POSITIONING NEW MOUNTING PLATES
FIG. 4-2
RH
MOUNTING
PLATE
MOUNTING PLATE
BRACKET (CUT LINES)
LH
MOUNTING
PLATE
3.
If mounting plate bracket interferes with
access to weld new mounting plate, cut
bracket down to no less than 1/4” above
the surface of the main frame (FIGS. 4-1
& 4-1A) to allow clearance for welding.
Repeat for RH side.
BRACKET CUT
TO NO LESS
THAN 1/4” ALL
AROUND
To Next Page
Loading...
