9
5) Connect the orange (Batt +) wire to your
vehicle's battery positive (+) terminal or to
a point in the vehicle's fuse box that provides
a continuous source of 12 Volts even when
the ignition is turned off. This connection
provides last channel memory feature.
6) Reconnect the cable to the vehicle's battery
negative (-) terminal.
MOBILE ANTENNA INFORMATION
Your Maxon MCB-45W requires a vehicle mount
CB antenna for operation. An antenna is not included
with your radio because of varying vehicle applica-
tions, individual needs, and owner cost preferences.
Maxon antenna model WTA-4WP may be obtained
from your local Maxon CB distributor / retailer or
you may use any standard 50 Ohm vehicle mount
CB/weather antenna with a PL-259 connector.
NOTE: When installing a mobile antenna, please
follow the antenna manufacturer's installation
instructions completely. Never operate your CB
radio without an antenna or with a broken antenna
cable. This can result in damage to your CB trans-
mitter circuitry.
• Connect the antenna securely to the radio's
antenna receptacle.
• Mount the antenna as high on the vehicle as
possible - the more the antenna extends above
the roof, the better the reception. If possible,
mount the antenna in the center of the surface.
• Keep the antenna cables away from noise sources
such as the ignition system, gauges, etc.
• Make sure you a have solid, metal-to-metal
ground.
To Next Page
Loading...
