Extended AT Commands Manual Page 16 of 70 2009-06-25
Command TE2
Æ
MT2 $$NOTIFCNT?
Value
0: No notification (No boot alert message, No SMS message notification.
Notifies of incoming data calls.)
1: No boot alert message on start-up but notifies when SMS message is
received. Notifies of incoming data calls
2: Notify Once (default) Boot up alert message on start-up and notifies when
SMS message is received. Notifies of incoming data calls
Table 3-9 Set command
Command TE2
Æ
MT2 $$NOTIFCNT=<value>
Response TE2
Å
MT2 $$NOTIFCNT: 1 | 0 (Success | Failure)
To Next Page
Loading...