Maxon MODMAX MM-6280IND - 12 Tia;Eia;Is-707 A at Command Set; User Modified Profiles & NVM Changes; User Profile Store (At&Wn); User Profile Recall (At&Fn)

Extended AT Commands Manual Page 55 of 70 2009-06-25
12. TIA/EIA/IS-707A AT COMMAND SET
12.1.1. User modified profiles & NVM changes
12.1.1.1. User Profile store (AT&Wn)
This command is used for saving the current operating profile as a User Profile.
Table 12.75 Set command
Command TE2
Æ
MT2 &W<value>
Response TE2
Å
MT2 (OK | ERROR)
Value 1~5 User Profiles slots available. 0 is Factory Default and is unavailable
12.1.1.2. User Profile recall (AT&Fn)
This command is used for confirming or recalling the User Profile. At each power up of modem or
&Fn command the profile set by &Fn is loaded into the working area of Memory.
If user has not saved a profile to &Fn an attempt to load that profile using &Fn will elicit an
ERROR response.
&F0 cannot be written to, using &W0 command. An attempt to write to that profile using &W0
will elicit an ERROR response.
Table 12.76 Read command
Command TE2
Æ
MT2 &F?
Response TE2
Å
MT2 &F: <value>
Value 0~5 (0: Factory Default Profile)
Table 12.77 Set command
Command TE2
Æ
MT2 &F<value>
Response TE2
Å
MT2 (OK | ERROR)