STATUS LED
* Your dealer or system supervisor may have disabled the
flashing green scan indicator.
AUDIBLE MESSAGES
Audible alerts, such as high and low tones, of long and short
duration, may be used. Your radio controller will be able to
give you details of the alerts used in your system.
USING THE PM100
Note: The availability of the functions described in this
section is dependent on the set-up of your radio. Please
consult your Dealer or Supervisor for further information.
ERROR ALERTS
Unprogrammed channel
If your radio has been set-up for less than the maximum
number of channels, turning to a blank channel will cause
your radio to beep and the status LED will flash red,
indicating that the channel is unusable.
Receive only channel
Your radio may be set-up to receive on a channel but not to
transmit. If the PTT is pressed on such a channel, the radio
will beep and the LED will flash red.
ENGLISH
7
Status Description Colour
Normal Power on ready Off
Busy Yellow
Receiving correct Green
CTCSS/DCS
Transmit Red
TX-lock out Yellow, flashing
Scanning Green, flashing*
Error EEPROM Error Red, flashing
PLL Error Red, flashing
Filtering Error Red, flashing
To Next Page
Loading...
