Maxon TSD-4000 Series - Quick Message

11
Figure 6-3) TSD-4424/4124 Analog Mode Main menu
☞ Note) Radio will revert to standby mode if no selection made in 25 seconds.
6.1.1 Contact (Digital Mode Only)
You can enter your contact list through the settings menu. Radio IDs are set by the radio’s PC
programmer. Select the radio ID you want to contact and press the PTT button to make a call. Contact
lists in the menu can be added, edited, or deleted using the radio’s programming software.
The Contact Menu displays “Individual”, “Group”, and “All Call” contacts using the following icons:
- : Individual contact list (individual calls, individual messages can be sent)
 Stun Radio, Revive Radio, Check Radio, & Monitor Radio functionality is
in this menu. “Stun” will disable the desired radio’s ability to Tx. “Revive” will
restore the functionality. “Check Radio” checks to see if the target radio in your
contact list is receiving. “Monitor Radio” turns on the mic of the target radio to
listen to the surrounding sound.
- : Group contact list (group call, group message can be sent)
- : All contact lists (terminals with the same channel and color code are available)
6.1.2 Messages (Digital Mode Only)
When a new message arrives and the radio is in receive mode, the message contents are displayed
on the display and the radio’s message menu appears. When a new message arrives during a
different radio operation, it will be displayed as a message icon.
The Message menu provides three additional menu functions: Quick Message, Inbox, and Outbox.
1) Quick Message
The radio holds 10 software programmable messages (each up to 40 characters) that the radio
sends via SMS in digital mode as a “Quick Message”. You get into the Quick Message menu
using your radio by entering the Main Menu and then select Messages. This will bring you to
the Messages menu. Select “Quick Text” to see the available messages to send. Highlight the
message you want to send and press the menu button to view the message contents. Press
the menu/select button again and highlight the recipient from your contacts list. Press select
button to select the recipient and send the message. Press and hold the select button to cancel,