14
Chapter 2 General Safety Information
(2) The power supply connected to the equipment, please make sure that the
protection ground is connected before use;
(3) In order to reduce the risk of fire, the line fuses can only be replaced by the
same type and the same level if necessary, and cannot be replaced by other
fuses or materials;
(4) Ensure that the laser input AC voltage is the normal AC mains voltage
(Single-phase alternating current 200-240VAC-1000X; single-phase alternating
current 200-240VAC-1500X; three-phase alternating current 360-440VAC-
1500X optional), and the wiring is correct. Any wrong wiring method may cause
personal or equipment damage;
(5) There are no parts, components or components that the user needs to
repair by himself. All maintenance work needs to be done by Chuangxin laser
professionals;
(6) Do not remove the casing, disassemble the laser and damage related labels,
there is a risk of electric shock or burns;
(7) Any product that has been disassembled and disassembled will no longer
enjoy warranty rights.
WARNING :
◎
The input voltage of the laser is (Single-phase alternating current
200-240VAC-1000X; single-phase alternating current 200-240VAC-1500X;
three-phase alternating current 360-440VAC-1500X optional), there is a
danger of electric shock. All related cables and connecting wires have potential
hazards.
5.Environment Conditions and Precautions
For ensuring the safety of the laser working area, suitable enclosures shall
be applied, including but not limited the laser safety signs and the interlocking
devices. Corresponding operators must be trained and examined and know the
normal safety specications for operating the laser.
Meanwhile, it is important that the output components shall not be installed
To Next Page
Loading...
Need help?
General
