23
Chapter 5 Unpacking Guide
where is far away from the laser and convenient for draining.
7、Keep all objects after unpacking for future transportation or storage
needs.
NOTES:
◎ If any damage of the external package and internal parts has been
found upon receipt of product, please contact Maxphotonics Co., Ltd. or
designated agent immediately.
◎ The air-conditioner at the back of the laser has ports for Water In/Out.
Please connect them with the external drainpipe and keep the drainpipe
flat and the Water Out port is higher than any part of the whole pipeline.
◎ If the ambient temperature and relative humidity are high enough
the laser will run a process of dehumidification for about 30 minutes. It is
normal and the laser should be reboot again after the Condense Warning
is released.
◎ The chiller should be closed when the laser is turned off in case that the
moisture in the air condense on cool parts within the laser. When an air-
conditioner is available it is suggested that you run the air-conditioner for
half an hour before turning on the chiller and the laser power switch.
Recommendation：Change the environmental temperature and relative
humidity and make the laser work away from the dew point (for example
keeping the laser in a room with air-condition).
To Next Page
Loading...
Need help?
General
