25
Chapter 6
Operation Guide
1-Notice
CAUTION:
◎ Please refer to Chapter 4 "Specification" for proper electrical power.
◎ Please refer to Chapter 2 "General Safety Information" for inspecting
whether the configuration environment of peripheral work of the laser
meets the requirements.
2-Electrical Power Connection
A power input cord of the laser shall be connected to triple-phase-
five-wire AC current. Please make sure the grounding cord is perfectly
connected, or the laser may be damaged potentially.
For ensuring the safety feature, Maxphotonics recommends you connect
a 20A circuit breaker (air switch) in series between the power supply unit
and the laser. This electric power shall be in close proximity to the power
supply unit of the equipment and can be easily disconnected.
Refer to Chapter 4 "Specification" to determine your electrical specification
if you have any problem about wiring.
3-Extension Interface
For ensuring the communication between the laser and the board
To Next Page
Loading...
Need help?
General
