Bluetooth
Pairing to a Smart Phone
Make sure the module is off and you have bluetooth enabled on your
smart phone. Press and hold down the Power/Intercom button for 8
seconds until you see a red and blue LED ashing.
Search for ‘MAXTEK BT’ from available device list on your smart
phone and select it. If your smart phone asks for a password please
use ‘0000’. The module will beep twice when the pairing is
successful.
Pairing to another Module
Make sure both receivers are turned off. Press and hold the
Power/Intercom for 8 seconds on both modules at the same time till
the LED’s are ashing blue and red. Quickly press one of the
modules Power/Intercom buttons to search for the other module.
When successfully paired together you will hear a beep and the LED
will ash blue.
It is possible to be paired to both a smart phone and another module
at the same time. The intercom function will be ended in favour of
answering an incoming call.
Reset the Pairing Memory
If you have problems pairing, try resetting the pairing memory.
Turn on the relevant unit into standby mode.
Press the Power/Intercom button for 3-5 seconds till a beep is heard.
This should be before the module switches off.
Let go of the button when the beep is heard.
After Sales Support
UK/N.IRELAND HELPLINE N
O
:
REP.IRELAND HELPLINE N
O
:
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
enquiries@quesh.co.uk
8
To Next Page
Loading...