MAXTEK 68426 - Fitting the Ear Pieces

After Sales Support
UK/N.IRELAND HELPLINE N
O
:
REP.IRELAND HELPLINE N
O
:
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
enquiries@quesh.co.uk
6
Fitting The Headset
Fitting the Ear Pieces
Find a comfortable spot close to your ears then
attach the adhesive velcro pads. This may take
several attempts to locate the best spot. Only
attach the pads once you are certain you have
the optimal position.
Once the pads are stuck in position attach the
two ear pieces, again making sure the
microphone is tted on the left of the helmet
(as you wear it).
The microphone must run along the wall of the
helmet and that the microphone end falls just
below the mouth and to the side.
Connect the bluetooth module to the mount and
then the micro USB connector to the module.
Secure any loose wiring by tucking it inside the
helmet padding.