5
After Sales Support
UK/N.IRELAND HELPLINE N
O
:
REP.IRELAND HELPLINE N
O
:
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
enquiries@quesh.co.uk
Fitting The Headset
Fitting the Mount
Undo the screws in the mount till the tips of the
screws are still intact with the mount.
Slip the mount over the bottom edge of the
helmet on the left side (as you wear it). Take care
to make sure the mount ts under the padding.
Adjust the mount till its in a preferred location
and that the clip mounts are facing outwards.
DO NOT over tighten the screw as you may
damage the mount.
Insert the bluetooth module to test that it ts
securely in place and that it doesn’t obstruct the
visor.
To remove the module, push back the clip on
the top of the mount and slid the module up.
To Next Page
Loading...