Charging Instructions
Charging the Bluetooth Module
Before using the device you will need to fully charge it.
Insert the USB charge cable into the nano USB port on the
module and the other end into a standard USB port or USB adaptor.
When charging you will see a red LED. Once the charge is complete
the red LED will turn off. A full charge normally takes about 4 hours.
Please Note:
To maintain your battery please use it till at and fully charge it for about 6 cycles,
then drain and fully charge it once a month after that.
7
After Sales Support
UK/N.IRELAND HELPLINE N
O
:
REP.IRELAND HELPLINE N
O
:
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
enquiries@quesh.co.uk
Turning On/Off
Turning On
To turn on the module, press the Power/Intercom button for 3
seconds until you hear a beep.
Turning Off
To turn the module off, press the Power/Intercom button for 5
seconds until you hear a beep. The module lights will turn off.
Please Note:
To maintain your battery please use it till at and fully charge it for about 6 cycles,
then drain and fully charge it once a month after that.
To Next Page
Loading...