Turning The Camera On
Press and hold the button for 3 seconds until you hear a beep(s).
This will turn the camera on and start it recording as well as the
light depending on the last setting used. The beeps heard will
indicate the current power level of the battery.
Turning On/Off
Beep indicator
4 Beeps
3 Beeps
2 Beeps
1 Beep
3 Long Beeps
Power Indicator
75% +
50% +
25% +
5% +
Under 5%
Please Note:
When the camera’s power reaches below 5% the camera function is disabled in
favour of the rear light. The light will last approximately 1.5 hours at this point.
Turning The Camera Off
Press and hold the button for 3 seconds until you hear a beep(s).
This will stop the recording and turn the camera and light off.
The beeps heard will indicate the power level left in the camera.
7
After Sales Support
UK/N.IRELAND HELPLINE N
O
:
REP.IRELAND HELPLINE N
O
:
WEBSITE:
EMAIL:
01270 508538
1800 995 036
www.quesh.co.uk
enquiries@quesh.co.uk
Beep Alerts
LED Flashing
If the LEDs round the lens are ashing the camera is not recording.
Make sure the micro SD card is inserted and/or turn on and off the
camera.
LED Chasing
If the LEDs are moving round the len the camera is recording.
To Next Page
Loading...