EN
User Manual
Battery replacement
If the
symbol appears on the display, it means that the
battery in the device is low. To replace, remove the test leads
from the instrument and the test jaws from any measured
circuit. Switch o the device. Then remove the battery
cover. Replace worn batteries with the same voltage and
size. (1.5 V, 2 X AAA) Pay attention to the polarity! Replace
the battery cover.
Maintenance
You can clean the sockets as follows
Make sure that the measuring jaws are not connected to a
circuit or measured object.
Turn o the device and remove the test leads.
Shake any dirt out of the socket.
Dip in isopropyl alcohol e.g. an ear swab and gently wipe
the sockets around.
Wipe the appliance regularly with a damp cloth or a mild
detergent cloth. Do not use solvents or abrasives. Dirt on
the substrates can cause erroneous measurement results.
accessories
1 user manual
1 pair of test leads
1 carrying case
To Next Page
Loading...
Need help?
General