ICE
ICE MAKER INSTALLATION
Unpacking
Remove packaging materials
NOTE: Do not remove any permanent instruction labels or the data label on your ice maker.
Remove tape and glue from your ice maker before using.
To remove any remaining tape or glue, rub the area briskly with your thumb.
Tape or glue residue can also be easily removed by rubbing a small amount of
liquid dish soap over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your ice maker.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your ice
maker before using it. See "Interior cleaning" in the Cleaning and Maintenance
section.
Excessive Weight Hazard
Use two or more people to move and install ice maker. Failure to
do so can result in back or other serious injury.
To Next Page
Loading...
