Maxx 20574 - Operation; Starting Cold Engine; Starting Warm Engine

OPERATION
Recoil starter: Use short pulls-only 1/2-2/3 of
rope length for starting.
Don't allow the rope to snap back in. Always
hold the unit firmly.
STARTING COLD ENGINE
1. Close Choke-Cold Start. Move choke (B)up
to “Cold Start”position.
2. Primer Buld-Prime. Pump primer bulb(C)
until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an
additional 4 or 5 times.
3.Move throttle lever(A)to START/IDLE
DETENT position. And move the stop switch
to "START" position. Then push choke lever
upwards(B) (excessive cranking with choke
lever will cause flooding engine making it
difficult to start.)
4.Press and release the Primer bulb until it is
filled with fuel(C).Pull recoil starter handle(D)
until engine fires(5 or 6 pulls)
5.Move choke (E)to run position and if
necessary, restart engine.
make sure the
button is locked
A
B
STARTING WARM ENGINE
1.Move throttle lever(A)to idle detent position.
And move the stop switch to "START"
position. Then push throttle level inwards
(excessive cranking with choke lever will
cause flooding engine making it difficult to
start.)
2.Pull recoil starter handle and engine should
start. Do not use choke(B)
-14-
fi