Ⅰ Ⅰ
Ⅰ
Ⅰ Ⅰ
Ⅰ
Ⅰ
Ⅰ
Ⅰ
Ⅰ
No Maintenance required for coil and flywheel
Time intervals shown are maximum. Actual
use and your experience will determine the
frequency of required maintenance.
All recommendations to replace are based on
finding damaged or wear during inspection.
(1)Repla c emen t will b e required f o r
Commerc ial use after 600 hours. For
Consumer use, cleaning every 6 months is
required.
Cleaning includes rebuild kits.
AIR FILTER
1. Close choke(Cold Start Position).This
prevents dirt from entering the carburetor
throat when the air filter is removed. Brush
accumulated dirt from the air cleaner area.
2. Remove the air cleaner cover. Clean and
inspect the element for damage If element is
fuel soaked and very dirty, replace.
3. If element can be cleaned and reused, be
certain it:
-still fits the cavity in the air cleaner cover.
-is installed with the original side out.
remo v e t w o
screws
foam filter
filter bracket
paper filter
IMPORTANT
To Next Page
Loading...