15
ENG
To be able to transport your training device easily and safely, the front stand is tted with transport rollers.
To transport the device, stand at the back and grab the rear stand with both hands. Lift the training device up-
wards until the weight rests on the transport rollers.
Now you can simply push the training device on its transport rollers to the desired position. When lifting, trans-
porting and positioning, always make sure that you have a secure footing.
Choose training area which allows you free space on all sides and the greatest possible security.
The safety area should always be at least 100 cm to each side, and 100 cm behind and in front of the training
device.
This exercise equipment has been designed for use only in dry, well-ventilated indoor areas. It must not be used
or stored in damp or wet areas such as saunas, swimming pools, etc. or in outdoor areas such as balconies, ter-
races, gardens, garages, etc. where high humidity and low temperatures may lead to defects in the electronics,
corrosion and rust. Damage of this kind is not covered by the warranty under any circumstances.
Please choose a dry, level and well-ventilated training or storage area. Make sure for your own sake that the
training location during exercise is suciently ventilated to provide optimal oxygenation.
Before you start using your training device after a long period of non-use, make sure be sure that all fastenings
are rmly and safely tightened.
CAUTION
Before starting cleaning, maintenance and / or repair work, the exerciser must be completely disconnected from
the power supply. This will only be the case if the mains cable is disconnected from the power socket and from
the training device. Therefore, rst disconnect the electrical plug from the power socket, and then disconnect the
mains cable from the exerciser. The mains cable may only be reconnected to the training device and the power
supply when all work has been completed and the proper functional condition of the device has been restored.
Cleaning
Clean your training device after each workout. Use a damp cloth and soap. Never use solvents. Regular clean-
ing contributes signicantly to the preservation and longevity of your training device. Due to the chemical com-
position of body sweat, this is the main cause of corrosion (rust) if not removed immediately. Therefore, after
every training session, check whether body perspiration and / or other uids have got onto the device. If this is
the case, the aected components / housing parts must be cleaned.
Please note that damages caused by body sweat or any other liquids are not in any way covered by the war-
ranty.
During training, make sure that no uid can enter the training device or the computer.
Transport
Safety Distance
Location and Storage
Maintenance & Care
To Next Page
Loading...
Need help?
General
