EasyManuals Logo

Maxxus MX-J306-01 User Manual

Maxxus MX-J306-01
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
18
f. After your sauna session is over, you can turn the control panel off by pressing the ON/OFF button.
You can unplug the sauna cord to protect the electronics from power surges.
g. To set the time, press the buttons. Press or buttons to set the timer from 5 to
60 minutes. If pressed for three seconds, the timer will increase/decrease quickly. When the time
expires, the timer will buzz and the sauna will shut off automatically. Please note that the light will
have to be physically turned OFF if it is ON. To extend the sauna session, reset the timer again by
pressing the .
h. The Fahrenheit and Centigrade display can be switched by pressing and holding the
TEMPERATURE side buttons and at the same time and then pressing the .
i. The Bluetooth function is built into the Control Panel. For the Bluetooth function, you first will need
to pair your device with the sauna room. Open your device’s Settings Menu and then locate and
open Bluetooth. You will find BT-AUDIO or “BT-SAUNA”. Now you can pair your device. Once
pairing is successful, your device will be connected. You will control the volume and choose the
music on your device.
j. The MP3 Jack will allow you to connect your musical device using the AUX wire. Plug one end of
the AUX wire into your musical device and the other end into the MP3 Jack at the ceiling. Do not
leave the AUX wire connected at the ceiling when not using this function as it may cause static
interference at the speakers. You will control the volume and choose the music on your device.
When you disconnect the MP3 wire, the sound system will automatically return back to the Bluetooth
mode.
Please Note: On average, it takes our model saunas approximately:
*20 minutes to reach into 100 degrees Fahrenheit/38 degrees Celsius (with a
starting temperature above 70 degrees Fahrenheit/21 degrees Celsius)
*25-30 mins to reach about 115-120 degrees Fahrenheit/46-49 degrees Celsius
(depending on sauna model)
*35-40 minutes to reach about 125-130 degrees Fahrenheit/52-54 degrees
Celsius (depending on sauna model)
*45-60 minutes to reach up to approximately 135 degrees Fahrenheit/57
degrees Celsius (depending on sauna model)
Please keep in mind that you can either preheat the sauna to the set temperature
before entering or sit inside the sauna as the temperature rises. In addition, you will
increase the time it takes for the sauna to reach the set temperature if you enter the
sauna room before it has reached the set temperature. Also, the most commonly
used temperature setting is between 118 degrees Fahrenheit / 48 degrees
Celsius and 122 degrees Fahrenheit / 50 degrees Celsius. The way the sauna room
works is when you set the Control Panel to say 120 degrees F / 49 degrees C, the
heat emitters will turn off when that set temperature is reached. And even though
the sauna does allow the user to set the Control Panel to 151 degrees F/66 degrees
C, this is specifically for those users who do not want the heat emitters to ever turn
off as the sauna room will never achieve 151 degrees F / 66 degrees C. After 3 hours
of continuous use, the sauna needs to be shut down for one hour.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Maxxus MX-J306-01 and is the answer not in the manual?

Maxxus MX-J306-01 Specifications

General IconGeneral
BrandMaxxus
ModelMX-J306-01
CategoryPlumbing Product
LanguageEnglish

Related product manuals