23
troubleshooting.
Solution: The control panel will not turn off, the power/work/or heat lights do
not come on, or the temperature and timer buttons do not work means the
control panel may have been damaged and will need to be replaced. Contact
the manufacturer for additional troubleshooting.
3. Sauna Shows Signs Of No Power
Solution: There could be one of a few problems causing this. First, check to see if
the cord from the power supply is plugged into the wall outlet. Also check your
main circuit breaker to confirm that it has not tripped. Check the power supply on
the roof of the sauna to make sure there are no signs of malfunctioning, such as a
high temperature, burning odor, or strange sounds. Also, check to make sure none
of the power cords are damaged. If the power supply is malfunctioning or power
cords are damaged, then unplug the sauna immediately and contact the
manufacturer.
Solution: If your sauna is plugged in and you have no power at the control
panel, then the power supply may need to be reset. Go to the roof of the sauna
and locate the power supply. Press the RESET button to reset the power supply.
The RESET button is on the same side of the power supply as all the heater cord
connections. Attempt to turn the sauna on at the control panel. Contact
the manufacturer for any additional troubleshooting.
Solution: There could be damage to the temperature sensor. If your sauna
arrived with a spare temperature sensor, turn the control panel off and go to the
roof of the sauna and locate the red and black wire near the air vent towards the
rear of the sauna. After you have located the red and black wires labeled “TEMP
SENSOR”, disconnect them. Connect the spare temperature sensor. For testing
purposes, insert the “TEMP SENSOR” (you just connected) down the vent on the
roof so that it is now inside the sauna. Then go to the control panel and press the
power button. If the heat emitters now heat, then the temperature sensor was the
cause of the problem. You may have to wait about five minutes to confirm if the
heat emitters are generating heat. Remove the original temperature
sensor from its hole and replace it with the spare one.
Solution: Check the wiring harnesses coming from the power supply located on
the roof of the sauna. Make sure the wiring harness labeled “CTRL” is connected
to the power supply at one end and connected to another wiring harness labeled
“CTRL” at the other end. If this wiring harness is not properly connected, then the
sauna will show signs of having no power.
4. CD Player Will Not Work
Solution: Check to make sure the lock screws on top of the radio have been
removed. The CD player will not work if the screws are not removed.
To Next Page
Loading...
Need help?
General
