Mayer MM038D - Controls and Operations; Before First Use and Operation Preparation; Operating the Oven Functions

5
Before rst use:
•
•
•
Note:
•
Before operating the oven:
1.
2.
3.
4.
Operating the oven:
1. Selecting cooking functions:
This oven comes with 10 preset functions. Turn the function knob to choose your preset
function and the selected function will start blinking on the LED display. For cooking time and
temperature information for the individual functions, please refer to the table in page 9.
For DIY function:
•
•
•
Note:
•
Wash all accessories in hot, soapy water.
Thoroughly dry all accessories and re-assemble in oven, plug oven into outlet and you are
ready to use your new toaster oven.
After re-assembling your oven, it is recommended to heat up the oven at the highest
temperature (230°C) for approximately 15 minutes to eliminate any packing residue that
may remain, and also remove all traces of odour which may be initially present in the oven.
The heating up of the oven for the rst time may result in minimal smell and smoke for
about 15 minutes. This is normal and harmless. It is due to burning of the protective layer
that is applied to the heating elements during manufacturing.
Plug oven into outlet and turn on main switch.
Place food ingredients onto accessories that will be used for cooking.
Place accessories and food ingredients into the oven.
Proceed to operating the oven.
Turn function knob slowly until none of the functions on the LED display is blinking.
When the functions on the LED display is not blinking, this means that the DIY function has
been selected.
To only use either top or bottom heating, only when using DIY function, press and hold the
button of the heating which you would like to turn o. For example, if you would like to
turn o the top heating, press and hold the upper heating control button. When the LED
display for the upper heating indicates "OFF", this means that the top heating element has
been turned o. To turn back on the upper heating, press the upper heating control button
again, and the LED display for the upper heating will change from "OFF" to the temperature
display.
When the oven is turned on, the function by default is DIY function.
CONTROLS AND OPERATIONS