Options
When the Options pad is pressed, six additional When either Sani Scrub or Quick Wash are
pads will light for a minimum of 30 seconds: selected, the indicator on the pad pressed will
SANI SCRUB, QUICK WASH, RINSE & light and a tone will sound. WASH, wash
HOLD, HEATED DRY, DELICATE WASH droplets, estimated cycle time and MIN will
AND CANCEL. appear in the display.
Wash Cycles When Rinse & Hold is selected, the indicator
ffyou prefer to use a cTele other than Smart on the pad will light and a tone will sound.
Start, you can choose Sani Scrub, Quick Wash RINSE, rinse droplets, estimated cycle time
or Rinse & Hold. Refer to the chart below for and MIN will appear in the display.
more information.
APPROX.
CYCLE SETTING SEQUENCE CYCLE TIME WATER USE
RINSE & HOLD:
Use to rinse a relatively few soiled dishes Rinse 6 Min. 2 Gal.
which are to be held until the dishwasher is
full. Press Rinse & Hold pad.
QUICK WASH:
Use to quickly wash dusty or very lightly Wash ] 5 Gal.
soiled dishes you wish to store or reuse 2 Rinses _- --17 Min.
immediately. Press the Quick Wash pad.
Dry }_ -- 35 Min. (optional)
SANI SCRUB:
Use for loads with heavy or dried soils. Press PreWash ] 1t Gal.
tile Sani Scnlb pad. 2 Rinses _ --75 Min.
Main Wash
2 Rinses
--35 Min,
Dry
110 Min. + Heating Delay*
*The FINAL RINSE is heated to approximately 150°F. The time required willvary depending on the water temperature
at the beginning of the rinse.
P,
To Next Page