Checkthatlevelinglegsarefirmlyagainstthefloor.
Closeandlatchthedoor,andplacelevelagainstthe
frontpanel.Checkthatdishwasheriscenteredfromfront
tobackintheopening.Ifneeded,adjustlevelingleguntil
dishwasherisplumb.Repeatforothersideofdishwasher.
Helpful"13p:Pushuponfrontofdishwashertoraise
dishwasheroffthegroundtoadjustfrontlegs.With
someinstallations,it maybeeasiertoadjustthefrontleg
usingthe3/16"hexheadsocketoradjustablewrench.
Placelevelagainsttopfrontopeningoftub.Checkthat
dishwasherislevelfromsideto side.Ifdishwasherisnot
level,adjustfrontlegsupordownuntildishwasheris
level.
Connect to Water Supply
Be sure rubber washer is properly seated in fitting. Slide
the 3/4"fitting up to the valve and hand-tighten to avoid
unintentional cross-threading. Hand-tighten until the
coupling is tight. Using pliers, check the tightness of the
coupling. An additional 1/4to 1/2turn may be required to
seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can
result.
Place paper towel under 90 ° elbow fitting. Turn on water
supply and check for leaks. If leak occurs, repeat
previous step.
17
To Next Page
Loading...
Need help?
General
