6-44
Clean shaft end with a dry, clean cloth.
To replace the tolerance ring, place it
on the shaft and apply a small amount of
grease on the outside of the tolerance ring.
TECH TIP: When reinstalling the basket
pulley, put the tolerance ring on the shaft
and secure it with a wire tie to keep it tight
to the shaft, apply a small amount of grease
on the outside of the tolerance ring. When
the pulley is about half way over it, cut and
remove the wire tie.
Start the pulley on the shaft by hand. The
finished side of the pulley faces the shaft.
Do not hammer pulley onto the main shaft,
because it can damage bearings and move
the main shaft from its correct position.
To push the pulley onto the shaft, insert
threaded rod #518910 into push bearing
#514691.
Screw the threaded rod into the center
hole of the shaft by hand until it is snug.
98.
99.
100.
101.
102.
Remove the bar wrench and use a 17mm
hex key to remove threaded rod and tools.
Reinstall the two side bolts before
removing the guide rods.
Use a 13mm wrench to remove the top
two guide rods.
Reinstall the top two bolts and snug them
with a 34mm socket.
Remove the two bottom guide rods and
reinstall the bottom two bolts.
Tighten all six of the bolts with a torque
wrench to 300 foot pounds. Tighten these
6 bolts in an opposing pattern around the
trunnion flange.
92.
93.
94.
95.
96.
97.
17mm
Hex Key
2 Side Bolt
Locations
Bottom
2 Bolts
Top 2 Bolts
To Next Page
