6-46
Remove the front panel (See page 4-19).
Remove the lower service panel
(See page 4-12).
Disconnect the door lock connector from the
control board.
Clip the wire ties to release the wire harness
from the cabinet.
Mark tub front panel on both sides of door
and measure distance from the floor to each
mark. Record this right on the panel for
proper door alignment during reassembly.
1.
2.
3.
4.
5.
REMOVE TUB FRONT PANEL - MFR80
Loosen, to the end of the bolt, both 13mm
nuts on both outer band clamps that secure
the tub front panel to the tub.
Support the tub front panel or it will fall off
when the band is removed.
Remove the band, then remove the tub front
panel with the door attached if it was not
removed earlier.
If the rubber seal does not come off with the
front panel, remove it from the tub as well.
6.
7.
8.
9.
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before
operating.
Mark Beside
Door
Outer Band
Clamps
Door Lock
Connector
To Next Page
