516532 B PUBLICATION DATE 1 JUN 2007.DOC PROGRAMMING MANUAL 51
DIAGNOSTIC CODE D14 : DOOR LOCK CHECK AT START FAILURE
The washing machine will not start a new process when the door is not locked after pressing the START button.
The Message DOOR is displayed.
When you open the door : the fault message is erased.
Exception :
If the „DOOR SWITCH“ is opened again just before the cycle has started, (the „DOOR SOLENOID SWITCH“
is still closed) Diagnostic Code D14 will also be generated.
DIAGNOSE(ERR8):
1. Check if the input connector A is connected If the input connector A is not connected : connect
connector A
2. Check the functioning of the
„DOOR SOLENOID SWITCH“
If the door switch is broken or functions not 100% :
replace the door lock system
3. Check the door lock coil If the door lock coil doesn’t function : replace the door
lock coil
4. Check the mechanical functionality of the
door lock
If the door lock is not functioning mechanically :
replace the door lock system
5. Check the continuity of the wiring If the wiring is not continuous : repair the wiring
6. Check the output relay that powers the door
lock coil
If the relay is broken, replace the wash computer
7. Check the functioning of the „DOOR
SWITCH“
If the door switch is broken or functions not 100% :
replace the door lock system
8. Check the door switch input at the wash
computer. (See Inputs at Toolbox Menu)
If the wash computer input is not functional replace the
wash computer board.
DIAGNOSTIC CODE D15 : OVERFILL FAILURE
If the target water level is X units above the target level then failure Diagnostic Code D15 will be displayed.
The fault message will not be generated when the user is advancing from a sequence with a high water level
to a sequence with a low water level.
X= „Max. level Overfill“, a value that can be programmed at the Initialization menu.
DIAGNOSE(ERR12):
1. Check if the water inlet valves are broken If the water inlet valves are broken: clean or replace
the water inlet valve diaphragms
2. Check if the water pressure is not to high Lower the water pressure
3. Check the output relay that powers the inlet
valve
If the relay stays closed and the relay is broken,
replace the wash computer
In Case of Steam Heating :
If the steam has not enough heating power (too low temperature), the machine will be filled with too much
water at the heating part. This will result in an increased water, energy and soap supply consumption.
It’s strongly recommended that the heating installation works with enough heating power.
A simple solution can also be to reduce the programmed target water level. As less steam will be required,
the normal water level should be reached. In the initialization menu it is also possible to adjust the alarm level
to avoid the error message. (= not recommended)
DIAGNOSTIC CODE D16 : COMM DEBIT CARD FAULT
If the Gen 2 Debit Card Reader is not communicating for 5 minutes with the wash computer anymore failure
Diagnostic Code D16 will be displayed.
The fault message will be cleared automatically when the communication is restored.
To Next Page
Loading...
