COM PLETE iNSTALLATiON
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended grounding
method. See "Electrical Requirements"
2. Check that all parts are now installed. If there is an extra part,
go back through the steps.
3. Check that you have all of your tools.
4. Dispose of/recycle all packaging materials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet hoses.
Electric Shock Hazard
This washer/dryer must be earthed.
Securely tighten all electrical connections.
Failure to do so can result in death, fire, or
electric shock.
7, Plug into a grounded outlet, or connect power.
8. To test and to clean your washer, measure 1/2 the detergent
manufacturer's recommended amount of High Efficiency (H E)
detergent for a medium-size load. Pour the detergent into the
detergent dispenser. Select any cycle and allow the washer to
complete one whole cycle.
9. Check dryer operation. Using a full heat cycle, let the dryer run
for at least five minutes. Dryer will stop when time is
used up.
NOTE: Dryer door must be closed for dryer to operate. When door
is open, dryer stops, but timer continues to run. To restart dryer,
dose door and push cycle button.
If the burner does not ignite and you can feel no heat inside
the dryer, shut off dryer for five minutes. Check that all supply
valve controls are in "ON" position and that the electrical cord is
plugged in. Repeat five-minute test.
23
To Next Page
Loading...
