Maytag MVWC200BW User Manual

5
CYCLE GUIDE
For best fabric care, choose the cycle that best ts the load being washed.
Recommended settings for best performance in bold.
Not all cycles and options are available on all models.
NOTE: If you are using fabric softener, be sure to select the One Rinse with Fabric Softener or Extra Rinse with Fabric Softener option.
*All rinses are cold.
Sturdy fabrics, colorfast
items, towels, jeans
Power Wash Hot
Warm
Cool
Cold
High Use this cycle for heavily soiled or sturdy items. Water-level sensing process
may take longer for some items than for others because they will absorb more
water than other fabric types.
Large items such as
sheets,sleeping bags,
small comforters, jackets,
small washable rugs
Bulky/Sheets Hot
Warm
Cool
Cold
High Use this cycle to wash large items such as jackets and small comforters. The
washer will ll with enough water to wet down the load before the wash portion
of the cycle begins, and uses a higher water level than other cycles.
Cottons, linens, and mixed
garment loads
Normal Hot
Warm
Cool
Cold
High Use this cycle for normally soiled cottons and mixed fabric loads. This cycle
uses spray rinses.
No-iron fabrics, cottons,
perm press, linens,
synthetics
Wrinkle Control Hot
Warm
Cool
Cold
Low Use this cycle to wash loads of no-iron fabrics such as sport shirts, blouses,
casual business clothes, permanent press, and blends.
Machine-wash silks,
handwash fabrics
Hand Wash Hot
Warm
Cool
Cold
Low Use this cycle to wash lightly soiled garments indicating “Machine Washable
Silks” or “Gentle” cycle on the care label. Place small items in mesh garment
bags before washing. This cycle uses a higher, preset water level.
Bright or darkly colored
cottons, linens, casual and
mixed loads
Cold Wash Cold High Cold water with an additional wash action gently lifts stains while caring for
fabrics. Settings may be adjusted as desired, but must use only cold water
settings.
Swimsuits and items
requiring rinsing without
detergent
Rinse &
Spin
Cold rinse only High Combines a rinse and high speed spin for loads requiring an additional rinse
cycle or to complete a load after power interruption. Also use for loads that
require rinsing only.
Hand-washed garments or
dripping wet items
Drain &
Spin
N/A High This cycle uses a spin to shorten drying times for heavy fabrics or special-care
items washed by hand. Use this cycle to drain washer after cancelling a cycle
or completing a cycle after a power failure.
No clothes in washer Clean Washer
with
affresh
®
Hot
Warm
Cool
Cold
Low Use this cycle every 30 washes to keep the inside of your washer fresh and
clean. This cycle uses a higher water level. Use with affresh
®
Washer Cleaner
tablet or liquid chlorine bleach to thoroughly clean the inside of your washer.
This cycle should not be interrupted. See “Washer Care.”
IMPORTANT: Do not place garments or other items in the washer during the
Clean Washer with affresh
®
cycle. Use this cycle with an empty wash tub.
Heavily soiled fabrics Soak Hot
Warm
Cool
Cold
No Spin Use this cycle to soak small spots of set-in stains on fabrics. The washer will
use intermittent agitation and soaking. After time has expired, water will drain,
but washer will not spin. Cycle is complete.
Items to wash: Cycle: Wash Temp*: Spin
Speed:
Cycle Details:
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear the
motor turning on briey (short hum) to move the basket
while lling. Fabric softener will be added if the One
Rinse with Fabric Softener or Extra Rinse with Fabric
Softener option was selected.
Some cycles use spray rinsing. After draining and
spinning out wash water, the washer will continue
to spin and spray in rinse water for the entire rinse
time.
SPIN
The washer spins the load at increasing speeds for
proper water removal, based on the selected cycle
and spin speed.
DONE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
LID LOCKED
To allow for higher spin speeds, the lid will lock and the
Lid Locked light will turn on. When this light is lit, the lid is
locked and cannot be opened. When this light is blinking,
the washer is paused. When this light is off, the lid can be
opened.
If you need to open the lid, press
START/Pause/Unlock. The lid will
unlock once the washer movement
has stopped. This may take several
minutes if the load was spinning at
high speed. Press START/Pause/
Unlock again to resume the cycle.

Maytag MVWC200BW Specifications

General

Brand	Maytag
Model	MVWC200BW
Category	Washer
Language	English