CARE AND CLEANING g
Refer to the chart on page 1'2and Adjusting the Interior Replacing the Interior Lights
on pages 3-5 ,,,,hen cleaning tbe refrigerator. I _
[ cavrxo i Di eon t p0w before/ tCAUTION: Disconnect the power cord be_e { r@Iaclng i_ht l_lbis_, Wear-gtove_ aS p_t_eti0n;/ _,
cleaning. Also, do not touch refrige'rated surfaces I _gainst pogSzble br0ke_glasSl ' , Iwith wet or damp hands. Damp objects sti& tothe
cold metal surfaces. Before cleaning _e freeZer, ¢,_
allow it to warm up. Allow glass shelves to Wa_ Up Refrigerator ¢_
before immersing in warm waterl , Two upper lights are located behind the fhll width light _;I
shield at the top back of the refrigerator compartment.
Cleaning Under the Refrigerator To replace the upper refrigerator bulbs: _
Your refrigerator can be rolled out for cleaning the floor 1. Unplug tbe refrigerator.
underneath. Simply unlock the front roller locks (see 2. Remove the light shield by grasping the bottom of the
page 1). Pull the refrigerator straight out from the wall. shield at each end and pulling forward to remove.
Cleaning the Defrost Pan .3. Lift up and remove the shield.
4. Unscrew the bulb and replace with a 40 watt appli-
The defrost water drains into a shallow pan beneath the ante bulb.
cabinet and evaporates. This pan should be cleaned
periodicallv with warm sudsy water. 5. Replace the light shield by hooking the top of the
• shield over the plastic pins, Secure the bottom of'the _-
To remove the defrost pan: shield by pushing in on middle edges of the shield at I K
1. Remove the base grille (see page 1). both ends.
2. Lift tile pan up and pull out. Freezer
To replace the defrost pan: Tile freezer light is located in the upper portion of the _
1. Position the side flanges to fit over the slide rails and fi'eezer compartment.
press down on the center of the pan to snap in place. To replace the freezer bulb:
2. Replace the base grille. 1. Unplug the refi-igerator.
2. Remove the ice bin (see page 9) and the i?ceezer shelf
(see page 5).
3. Unhook the tabs on the top of the light shield by
pressing in with wmr thumb on the center top of the
light shield. Pivot tile shield dou_. _"
ar_
4. Unscrew the bulb when cool and replace it with a
standard 40 watt appliance bulb.
5. Pivot the shield up into place, snapping the tabs into
the slots. Replace the freezer shelf and ice bin.
lee and Water Dispenser
To replace the dispenser bulb:
1. Unplug tile refiigerator
2. Reach up behind the decorative panel on the right
side, unscrew the bulb and replace it with a 7 watt
appliance bulb.
PAGE 11
To Next Page
Loading...
