6
English
Turning the Pulit E70 on
Part 3 - Taking the Pulit E70 out of the water
Unplug power supply before any servicing activity.
If the Pulit E70 has not finished its cycle, turn off the power supply 1.
unit and unplug the mains.
Pull the floating cable gently until the Pulit E70 has risen to the 2.
surface, then lift by the handle.
Plug the floating cable from the Pulit E70 1.
into the power supply unit.
Plug the electrical cable from the power 2.
supply unit into the mains.
Press the ON/OFF switch 3.
The Pulit E70 will now start to work.4.
Important: Do NOT lift the Dolphin from the water by its cable.
Floating cable
ON
On/Off
switch
Note : If your model includes the remote control unit, please refer to the included instruction leaflet.
To Next Page
Loading...
