Maytronics Pulit E70 - Section 4 - Storage Advice

8
English
Reinstall the filters according to the diagram
DO NOT FORCE THE FILTERS INTO PLACE.
Part 2 - Dismantling and cleaning the impeller
Unplug power supply before any servicing activity.
Dismantle the impeller cover and
clean around the impeller housing,
then reassemble.
Grooved end fitting
Octagonal end fitting
Important: Where applicable, you must reset the full filter bag indicator on the power supply unit.
Important: When storing a Pulit E70 with Combined or Wonder brushes, please note to keep the brushes wet at all times.
Recommendation: Rinse all brushes with clean water after each cleaning cycle.
Coil the cable and store in dry cool area – preferably on the Caddy if available.
Do NOT store the Pulit E70 exposed to direct sunlight.
Do NOT store the Pulit E70 exposed to excessive heat.
Do NOT store the Pulit E70 exposed to frost.
Section 4 – Storage Advice
2
3
1