7. After pulling the blade rubber in the
direction of the arrow and sliding
the blade rubber to a position to
check the blade holder groove,
slide the blade rubber end in the
opposite direction.
8. Make sure that the blade rubber is
correctly installed to the blade
holder.
9. Slide the blade component and
install it to the wiper arm.
10.Slowly lower the wiper arms onto
the windshield.
11.Move the wipers to their initial
positions using the following
procedure.
a) Make sure that the wipers are set
on the windshield.
b) Switch the ignition ON.
c) Press up the wiper switch to the
MIST position 1 time.
When the procedure is
completed, the wipers operate
and they stop at the initial
positions.
▼
Replacing Rear Window Wiper
Blade
When the wiper no longer cleans well,
the blade is probably worn or cracked.
Replace it.
CAUTION
To prevent damage to the wiper arm
and other components, do not move
the wiper by hand.
Maintenance and Care
Owner Maintenance
6-26
CX30_8JP5-EA20K_Edition1_new 2020-7-22 15:50:09
To Next Page
Loading...
