CAUTION
Align the notch on the wheel cover
with the valve stem when installing
it.
1. Notch
2. Tire valve
Damage could occur during
installation if the wheel cover is not
properly aligned.
2. Loosen the lug nuts by turning them
counterclockwise one turn each,
but do not remove any lug nuts
until the tire has been raised o the
ground.
NOTE
If your Mazda is equipped with the
optional antitheft wheel lug nuts, a
special key must be used to unlock
the locking lug nut for each wheel.
For details, refer to the Locking Lug
Nuts on page 7-10.
3. Place the jack on the ground.
4. Turn the jack screw in the direction
shown in the figure and adjust the
jack head so that it is close to the
jack-up position.
1. Jack head
5. Place the jack under the jack-up
position closest to the tire being
changed with the jack head
squarely under the jack-up point.
1. Jacking position
If Trouble Arises
Flat Tire
7-7
CX30_8JP5-EA20K_Edition1_new 2020-7-22 15:50:09
To Next Page
Loading...
