Mazda CX-30 - Page 64

Installation on rear center seat
The ISOFIX/LATCH
*1
lower anchors at
the center of the rear seat are much
further apart than the sets of ISOFIX/
LATCH
*1
lower anchors for
child-restraint system installation at
other seating positions. Child-restraint
systems with rigid ISOFIX/LATCH
*1
attachments cannot be installed on the
center seating position. Some ISOFIX/
LATCH
*1
equipped child-restraint
systems can be placed in the center
position and will reach the nearest
ISOFIX/LATCH
*1
lower anchors which
are 415 mm (16.3 in) apart. ISOFIX/
LATCH
*1
compatible child-restraint
systems (with attachments on belt
webbing) can be used at this seating
position only if the child-restraint
system manufacturer's instructions
state that the child-restraint system can
be installed to ISOFIX/LATCH
*1
lower
anchors that are 415 mm (16.3 in)
apart. Do not attach two child-restraint
systems to the same ISOFIX/LATCH
*1
lower anchor. If your child-restraint
system has a tether, it must also be
used for your child's optimum safety.
The procedure is the same as the
installation for the rear outboard seats.
*
1 ISOFIX (Mexico)/LATCH (Except
Mexico)
ISOFIX/LATCH
*1
lower anchor
location
WARNING
Always remove the head restraint and
install child-restraint system (except
when installing a backless booster
seat):
Installing a child-restraint system
without removing the head restraint is
dangerous. The child-restraint system
cannot be installed correctly which
may result in death or injury to the
child in a collision.
(Except Mexico)
1. Tether strap
2. Anchor bracket
3. Forward
Always attach the tether strap to the
correct tether anchor position:
Attaching the tether strap to the
incorrect tether anchor position is
dangerous. In a collision, the tether
strap could come o and loosen the
child-restraint system. If the
child-restraint system moves it could
result in death or injury to the child.
Essential Safety Equipment
Child Restraint
2-50
CX30_8JP5-EA20K_Edition1_new 2020-7-22 15:50:09