Turning on the system
OFF/CANCEL
switch
RES switch
SET- switch
SET+ switch
switch
switch
MODE switch
When the MODE switch is pressed once, the MRCC system turns on, and the MRCC main
indication (white) turns on and the vehicle speed and the distance between the vehicles
while in headway control can be set.
In addition, the MRCC system display indication is displayed on the multi-information
display and the active driving display at the same time.
NOTE
If the ignition is switched off while the MRCC system is operating, the system will be
operable when the ignition is switched ON the next time.
The MRCC can switch to the Cruise Control Function.
Refer to Cruise Control Function on page 4-107.
How to set the speed
1. Adjust the vehicle speed to the desired setting using the accelerator pedal.
2. Headway control begins when the SET
or SET switch is pressed.
The set speed and the inter-vehicle distance display filled with white lines is displayed.
The MRCC main indication (white) switches to the MRCC set indication (green) at the
same time.
When Driving
i-ACTIVSENSE
4-103
CX-8_8HJ9-EI-19E_Edition2_old 2020-4-15 13:00:04
To Next Page
Loading...
