EasyManua.ls Logo

Mazda Mazda5 - Page 140

Mazda Mazda5
380 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (140,1)
NOTE
l
If any one of the following operations is performed after the engine has been
automatically stopped, the engine will restart automatically even though the brake
pedal is not released.
l
The i-stop OFF switch is pressed for several seconds.
l
The temperature control dial for the air-conditioning system is set to the maximum
hot or cold position.
l
The windscreen defroster switch is on.
l
The driver intends to get out of the vehicle (driver's seat belt is unfastened and any
door or the liftgate is opened).
l
The brakes are released slightly on a slope and the vehicle begins to move.
l
The accelerator pedal is depressed while the shift lever is in the D/M position (not
second gear fixed mode).
l
The shift lever is shifted to the R position.
l
The shift lever is shifted from the N or P position to the D/M position (not second
gear fixed mode).
l
The steering wheel is operated with the shift lever in the D/M position (not second
gear fixed mode).
l
The shift lever is in the D/M position, second gear fixed mode.
l
If any one of the following vehicle conditions occur after the engine has been
automatically stopped, the engine will restart automatically even though the brake
pedal is not released.
l
There is a large difference between the cabin temperature and the temperature set
for the air-conditioning system.
l
Two minutes have elapsed since the i-stop function started operating.
l
The battery power is depleted.
l
If any one of the following occurs, the length of time the engine is stopped
automatically could be shorter or the length of time required before i-stop functions
again could be longer.
l
The ambi ent temperature is high or low.
l
The battery power is depleted.
l
The power consumption of vehicle equipment is high.
l
The i-stop function does not operate when the ambient temperat ure is extremely high
or low.
l
The engine may not stop automatically for a while after the battery leads are
reconnected after temporarily disconnecting them. In addition, if the battery is
replaced, the i-stop system will need to be reset and checked to make sure it operates
correctly. When replacing the battery, consult an expert repairer, we recommend an
Authorised Mazda Repairer.
5-10
Driving Your Mazda
Starting and Driving
Mazda5_8DF6-EI-13J_Edition7 Page140
Thursday, March 9 2017 8:34 PM
Form No.8DF6-EI-13J

Table of Contents

Related product manuals