Mazda Mazda5 - Child-Restraint System Installation Position

Black plate (49,1)
Child-Restraint System
Installation Position
In this owner's manual, explanation of
child-restraint systems secured with seat
belts is provided for the following three
types of popular child-restraint systems:
baby seat, child seat, junior seat.
NOTE
l
Installation position is determined by
the type of child-restraint system.
Always read the manufacturer's
instructions and this owner's manual
carefully.
l
Due to variations in the design of
child-restraint systems, vehicle seats
and seat belts, all child-restraint
systems may not fit all seating
positions. Before purchasing a child-
restraint system, it should be tested
in the specific vehicle seating
position (or position s) where it is
intended to be used. If a previously
purchased child-restraint system
does not fit, you may need to
purchase a different one that will.
Please comply with the legal regulations
concerning the use of child-restraint
systems in your country.
qBaby Seat Installation Position
A baby seat is used in the rear-facing
position only.
WARNING
Never use a rear-facing child-restraint
system on the front passenger seat
protected by an air bag:
NEVER use a rearward facing child
restraint on a seat protected by an
ACTIVE AIRBAG in front of it,
DEATH or SERIOUS INJURY to the
CHILD can occur.
The child-restraint system can be hit
by the deploying air bag and knocked
out of position. A child in the child-
restraint system could be seriously
injured or killed.
Essential Safety Equipment
Child Restraint
2-39
Mazda5_8DF6-EI-13J_Edition7 Page49
Thursday, March 9 2017 8:34 PM
Form No.8DF6-EI-13J