Black plate (191,1)
NOTE
l
If the windscreen is coated with
water repellent, the rain sensor may
not be able to sense the amount of
rainfall correctly and auto-wiper
control may not operate properly.
l
If dirt or foreign matter (Such as ice
or matter containing salt water)
adheres to the windscreen above the
rain sensor or if the windscreen is
iced, it could cause the wipers to
move automatically. However, if the
wipers cannot remove this ice, dirt or
foreign matter, the auto-wiper
control will stop operation. In this
case, set the wiper lever to the low
speed position or high speed position
for manual operation, or remo ve the
ice, dirt or foreign matter by hand to
restore the auto-wiper operation.
l
If the auto-wiper lever is left in the
AUTO position, the wipers could
operate automatically from the effect
of strong light sources,
electromagnetic waves, or infrared
light because the rain sensor uses an
optical sensor. It is recommended
that the auto-wiper lever be switched
to the OFF position other than when
driving the vehicle under rainy
conditions.
qWindscreen Washer
Pull the lever toward you and hold it to
spray washer fluid.
Washer
OFF
NOTE
With the wiper lever in the OFF or
intermittent position/AUTO position,
the wipers will operate continuously
until the lever is released.
If the washer does not work, inspect the
fluid level (page 8-19). If it's normal,
consult an expert repairer, we recommend
an Authorised Mazda Repairer.
Driving Your Mazda
Switches and Controls
5-61
Mazda5_8DF6-EI-13J_Edition7 Page191
Thursday, March 9 2017 8:35 PM
Form No.8DF6-EI-13J
To Next Page
Loading...
